Alarm messages
74
Alarm messages
The alarm key light flashes on the reception tele-
phone during alarm messages and the correspond-
ing message is displayed. An alarm signal is also
sounded. This audible signal can be activated or
deactivated as required (
→ page 71).
The following alarm messages may occur during
operation:
Alarm message: Possible cause: Corrective measure:
Printer is not re-
sponding
The printer is
switched off.
Switch the printer on.
The printer is not
connected.
Connect the printer and switch it on.
The printer is offline. Switch the printer to online (if neces-
sary, check why the printer is offline,
e.g. because of a paper blockage).
There is no paper in
the printer.
Insert paper, switch the printer to
online.
Wakeup unsuc-
cessful
The guest has not
responded to the
wakeup signal.
Waken the guest.
Caracas.bk Seite 74 Donnerstag, 11. April 2002 4:22 16
To Next Page
Loading...
