Siemens MICROMASTER 430 - Page 68

5 System parameters
MICROMASTER 430 Operating Instructions
6SE6400-5AC00-0BP0
67
ParNr ParText Default Level DS QC
P1323[3] Programmable V/f volt. coord. 2 0.0 3 CUT N
P1324[3] Programmable V/f freq. coord. 3 0.00 3 CT N
P1325[3] Programmable V/f volt. coord. 3 0.0 3 CUT N
P1330[3] CI: Voltage setpoint 0:0 3 T N
P1333[3] Start frequency for FCC 10.0 3 CUT N
r1337 CO: V/f slip frequency - 3 - -
P1335[3] Slip compensation 0.0 3 CUT N
P1336[3] Slip limit 250 3 CUT N
P1338[3] Resonance damping gain V/f 0.00 3 CUT N
P1340[3] Imax controller prop. gain 0.000 3 CUT N
r1343 CO: Imax controller freq. output - 3 - -
P1341[3] Imax controller integral time 0.300 3 CUT N
r1344 CO: Imax controller volt. output - 3 - -
P1345[3] Imax controller prop. gain 0.250 3 CUT N
P1346[3] Imax controller integral time 0.300 3 CUT N
P1350[3] Voltage soft start 0 3 CUT N
Communication (P0004 = 20)
ParNr ParText Default Level DS QC
P0918 CB address 3 2 CT N
P0927 Parameter changeable via 15 3 CUT N
r0965 Profibus profile - 3 - -
r0967 Control word 1 - 3 - -
r0968 Status word 1 - 3 - -
r0964[5] Firmware version data - 3 - -
P0971 Transfer data from RAM to EEPROM 0 3 CUT N
P2000[3] Reference frequency 50.00 2 CT N
P2001[3] Reference voltage 1000 3 CT N
P2002[3] Reference current 0.10 3 CT N
P2003[3] Reference torque 0.75 3 CT N
r2004[3] Reference power - 3 - -
P2009[2] USS normalization 0 3 CT N
P2010[2] USS baudrate 6 3 CUT N
P2011[2] USS address 0 3 CUT N
P2012[2] USS PZD length 2 3 CUT N
P2013[2] USS PKW length 127 3 CUT N
P2014[2] USS telegram off time 0 3 CT N
r2015[8] CO: PZD from BOP link (USS) - 3 - -
P2016[8] CI: PZD to BOP link (USS) 52:0 3 CT N
r2018[8] CO: PZD from COM link (USS) - 3 - -
r2024[2] USS error-free telegrams - 3 - -
P2019[8] CI: PZD to COM link (USS) 52:0 3 CT N
r2025[2] USS rejected telegrams - 3 - -
r2026[2] USS character frame error - 3 - -
r2027[2] USS overrun error - 3 - -
www.eltra-trade.com
+421 552 601 099
info@eltra-trade.com