7 Operation at Use of a PC
7.6 Example of a Parameterization and Measured Value Evaluation for SENTRON PAC5200
184 SENTRON PAC5100/5200, 7KM5212/5412, Device Manual
E50417-H1040-C568-A1, Edition 03.2015
7.6 Example of a Parameterization and Measured Value Evaluation for
SENTRON PAC5200
7.6.1 Task Definition
✧ Set the parameters via the Ethernet interface using the default IP address set upon delivery of the device.
✧ Configure SENTRON PAC5200 according to the topology.
✧ Parameterize the indication of a measurand limit violation for V
ab
> 11 kV with 10 % hysteresis and name
the indication.
✧ Parameterize a binary output that is switched on for the duration of the measurand limit violation.
✧ Parameterize the Ethernet communication according to the network configuration specified by the system
operator.
✧ Assign any name and specify the time/date format as YYYY-MM-DD and the time in 24-hour format.
✧ Parameterize the Measurement recorder with an averaging time of 2 hours and activate the averaging
recorders for minimum and maximum values. Record all voltage harmonics.
✧ Allocate 50 % storage capacity to the Measurement recorder.
✧ Take over the factory-set report configuration.
✧ Activate the device configuration you have created as the active parameter set.
✧ Perform measurements, acquire the measurand limiting value indication and record the measured values
as defined in the task.
7.6.2 Initial Situation
Topology
• 4-wire system, unbalanced
• Primary nominal voltage: 400 V
• Voltage transformer: 10 000 V : 100 V
• Primary rated current: AC 100 A
• Current measurement range: 1 A
• Current transformer: 100 A : 1 A
• Rated frequency: 50 Hz
• Communication via Ethernet interface
Network Configuration
• IP address: 192.168.0.55
• Subnet mask: 255.255.255.0
• Default gateway: 192.168.1.1
To Next Page
Loading...
