5 Getting Started
5.2 Assembly
71SENTRON PAC5100/5200, 7KM5212/5412, Device Manual
E50417-H1040-C568-A1, Edition 03.2015
5.2 Assembly
5.2.1 General Assembly Notes
Depending on the model, SENTRON PAC5100/5200 is designed either for panel flush mounting (device with
display) or for DIN rail assembly (device without display).
• The installation site must be vibration-proof. The permitted ambient temperature must be observed (see
the technical data in chapter 12).
• Operating the device outside the permitted operating temperature range can lead to measuring errors and
device failure.
• The terminals are designed for wire cross-sections of 2.5 mm² max.
• The device must not be exposed to condensation during operation.
• Install the device in a location where it is not exposed to direct sunlight and strong temperature variations.
WARNING
Do not touch any live parts.
Non-observance may lead to death or serious injury.
✧ After installation of the device and wiring, close the control cabinet.
To Next Page
Loading...
