Siemens SENTRON PAC5200 - Binary Outputs

14 Operating Parameters
14.1 Process Connections
245SENTRON PAC5100/5200, 7KM5212/5412, Device Manual
E50417-H1040-C568-A1, Edition 03.2015
14.1.2 Binary Outputs
Parameter Default Settings Setting Range
Source type Indication Indication
Energy counter
Indication
(only if source type = indication)
-none- -none-
Device OK
Battery Failure
Settings Load
Settings Check
Settings Activate
Modbus TCP OK
Ethernet Link Error
Time Synchronization Error
Primary NTP Server Error
Secondary NTP Server Error
Daylight Saving Time
Default IP Address
Limit Violation y (y = 1 to 16)
Indication 1 from Remote
Indication 2 from Remote
Rotation Voltage Clockwise
Group Indication x (x = 1 to 4)
SD Card Error
Supply Voltage Event Available
Frequency Event Available
Voltage Unbalance Event Available
Energy counter
(only if source type = energy coun-
ter)
-none- WPa_sup
WPb_sup
WPc_sup
WP_sup
WPa_dmd
WPb_dmd
WPc_dmd
WP_dmd
WQa_ind
WQb_ind
WQc_ind
WQ_ind
WQa_cap
WQb_cap
WQc_cap
WQ_cap
WSa
WSb
WSc
WS
Source inverted
(only if source type = indication)
no no
yes