7 Operation at Use of a PC
7.2 Start and Design of the User Interface
97SENTRON PAC5100/5200, 7KM5212/5412, Device Manual
E50417-H1040-C568-A1, Edition 03.2015
7.2 Start and Design of the User Interface
7.2.1 Initial Start of the Operation
Before starting the user interface, the following preconditions must be satisfied:
✧ Assemble the SENTRON PAC5100/5200 as described in Assembly.
✧ Connect the lines for measurement, communication and supply voltage as described in Electrical
Connection and observe the safety provisions.
✧ Switch on the devices needed for the measurement.
✧ Switch on the supply voltage of the SENTRON PAC5100/5200.
✧ Check whether the LEDs at the SENTRON PAC5100/5200 indicate that the device is ready (see
Dimensions).
✧ Match the IP address and the subnet mask of the network interface card of your computer to the device
settings.
✧ Check on the computer screen whether the LAN connection is up. Activate the LAN connection if it is down
(see the Windows manual or the Windows online help for information).
✧ For checking purposes, carry out the ping test as follows (example for Windows XP):
Click Start on the Windows interface.
Select Execute....
Enter cmd in the dialog and click OK.
Enter: ping 192.168.0.55.
Press ENTER.
Check the following output in the window.
Figure 7-1 Ping Test
✧ Start Microsoft Internet Explorer.
✧ Enter the IP address in Microsoft Internet Explorer (for example default IP address: http://192.168.0.55)
of SENTRON PAC5100/5200 and press ENTER.
The user interface opens with the Information tab Show device information (see Figure 7-4).
To Next Page
Loading...
