Siemens SENTRON PAC5200 - Page 209

8 Operation at Use of the Display
8.4 Parameterization
209SENTRON PAC5100/5200, 7KM5212/5412, Device Manual
E50417-H1040-C568-A1, Edition 03.2015
Password Protection
If you have selected the option Use password = no on the HTML page (see Chapter 7.3.4.1), you can use the
softkeys to parameterize the device without entering a password.
If you have selected the option Use password = yes on the HTML page (see Chapter 7.3.4.1), you must first
enter the activation password (default setting 000000) before you can edit the device settings. A prompt is
displayed for this purpose.
After you have entered the correct password, you can edit the parameterization using the softkeys within the
next 15 minutes. After this time you have to re-enter the password at the device.
Mode lower than greater than
smaller than
Value 0 -1 000 000 000 to +1 000 000 000 (unit)
Reset hysteresis 1.0 % 0.0 % to 10.0 %
State ON ON
OFF (O)
acc. to current configuration
Record
Recording on No
(no checkmark)
Yes (checkmark)
No (no checkmark)
Reset
Clear MIN/MAX val No
(no checkmark)
Yes (checkmark)
No (no checkmark)
Reset counters No
(no checkmark)
Yes (checkmark)
No (no checkmark)
in process
(prompt whether selected function is
executed)
-NO
OK
Table 8-8 Advanced Settings (cont.)
Parameter Default Setting Setting Range