Siemens SENTRON PAC5200 - Page 224

11 Failures and LED Indications
11.3 Indications Signaled by LEDs
224 SENTRON PAC5100/5200, 7KM5212/5412, Device Manual
E50417-H1040-C568-A1, Edition 03.2015
Boot loader was started because an error occurred in the process
application.
The IP address was configured or received from DHCP.
DHCP active (LED H1 switches off after reception of the IP address
via DHCP)
Boot loader started, process application is being loaded.
Double IP address is detected
Process Application
Normal mode:
IP address has been configured or received from DHCP.
DHCP:
LED RUN (green) is lit after the IP address was received from the DHCP
server.
The default IP address was confirmed by pressing the F4 softkey.
Table 11-1 Indications Signaled by LEDs on the Top Side of the Housing (cont.)
LED Meaning
RUN ERROR
H1 H 2
RUN ERROR
H1 H 2
RUN ERROR
H1 H 2
RUN ERROR
H1 H 2
RUN ERROR
H1 H2
C C
ERRORRUN
H1 H2
C C
ERROR
RUN ERROR
H1 H2
C
C