5 Getting Started
5.7 Commissioning
82 SENTRON PAC5100/5200, 7KM5212/5412, Device Manual
E50417-H1040-C568-A1, Edition 03.2015
DIN Rail Devices
✧ Press the IP-Addr. push-button on the DIN Rail Site for at least 3 s.
Figure 5-7 Location of the Push-button for Activating the Default IP Address
When you press the IP-Addr. push-button, SENTRON PAC5100/5200 will reset and use the default IP
address until you have set a new IP address or switched the device off and on again.
IP-Addr. push-button for
default IP address
Default IP Address : 192 . 168 .0 .55
Default Subnet M ask : 255 .255 .255 .0
NOTE
Changing the IP address will lead to a device reset, and the LEDs indicate that the device was started with the
default IP address (see chapter 12.3).
In this case, the parameterized IP address and the default IP address are displayed on the Information tab,
Device information item (see chapter 7.2.5).
When the device has started with the default IP address, the factory-set default passwords are also active (see
chapter 7.3.6.3).
To Next Page
Loading...
