Siemens SIMATIC ET 200SP CM 1xDALI - Set Control Gear Extended Parameters

CM 1xDALI command list
3.4 Configuration
ET 200SP CM 1xDALI Communication Model Description
Programming Manual, 12/2019, A5E47581955-AA
37
Control Gear Type 8 (color control)
Byte 2
Power on color type
Byte 3 to 4
Power on color value 1, coordinate-x or color temperature.
Byte 5 to 6
Power on color value 2, coordinate-y.
Byte 7 System failure color type
Byte 8 to 9
Power on color value 1, coordinate-x or color temperature.
Byte 10 to 11
Power on color value 2, coordinate-y.
Byte 12 to 13
Color temperature physical coolest.
Byte 14 to 15
Color temperature physical warmest.
Byte 16 to 17
Color temperature coolest
Byte 18 to 19
Color temperature warmest
3.4.6 Set control gear extended parameters
Description
Use this CM command to set the type-related parameters of a control gear.
Only control gear types 1 to 8 have type-related parameters. Control gears of other
types return a 16#87 (not supported) error in the response parameter.
Command ID
26
Input Param-
eters
Byte 0
Short address
Byte 1
Control gear type
Byte 2 to 19
Type-related parameters (Page 35)
Response
Parameters
Byte 0 Return code (Page 51)