Siemens SIMATIC ET 200SP CM 1xDALI - Set Instance Parameters of Input Device; Start Download Input Device Parameters; Start Upload Input Device Parameters

CM 1xDALI command list
3.4 Configuration
ET 200SP CM 1xDALI Communication Model Description
Programming Manual, 12/2019, A5E47581955-AA
45
3.4.21 Set instance parameters of input device
Description
Use this CM command to set the type-related parameters of one instance in a input
device.
Note: Only input device types 1 to 4 have type-related parameters.
Command ID
40
Input Param-
eters
Byte 0
Short address of the input device
Byte 1
Instance number
Byte 2
Input device type
Byte 3
Instance active flag
Byte 4
Event scheme
Byte 5
Event filter
Byte 6
Event priority
Byte 7 to 10
Type-related parameters (Page 44)
Response
Parameters
Byte 0 Return code (Page 51)
3.4.22 Start download input device parameters
Description
Use this CM command to send the parameters saved in the CM 1xDALI to the physi-
cal input device.
You can check the download progress by "querying the current command progress
(Page 49)".
Command ID
41
Input Param-
eters
Byte 0 Short address of the input device
Response
Parameters
Byte 0 Return code (Page 51)
3.4.23 Start upload input device parameters
Description
Use this CM command to query the parameters of the physical device, and save them
in the CM 1xDALI.
You can check the upload progress by "Query current command progress (Page 49)".
Command ID
42
Input Param-
eters
Byte 0 Short address of the input device
Response
Parameters
Byte 0 Return code (Page 51)