Siemens SIMATIC ET 200SP CM 1xDALI - Remove Control Gear from Groups; Query Control Gear Scene

CM 1xDALI command list
3.4 Configuration
ET 200SP CM 1xDALI Communication Model Description
Programming Manual, 12/2019, A5E47581955-AA
39
3.4.9 Remove control gear from groups
Description
Use this CM command to remove the control gear from some groups.
Command ID
29
Input Param-
eters
Byte 0
Short address of the control gear
Byte 1 Remove from group 0 to 7.
Each bit indicates one group: for example, Bit 0 is for group 0; bit 1 is
for group 1.
• 1: remove from this group
• 0: no action
Byte 2 Remove from group 8 to15.
Each bit indicates one group: for example, Bit 0 is for group 8; bit 1 is
for group 9.
• 1: remove from this group
• 0: no action
Response
Parameters
Byte 0 Return code (Page 51)
3.4.10 Query control gear scene
Description
Use this CM command to query the scene level and color of a control gear.
Command ID
30
Input Param-
eters
Byte 0
Short address of the control gear
Byte 1
Scene number
Byte 2 Query actual device flag.
• 0: query the scene configuration saved in the CM 1xDALI.
• 1: query the scene configuration on the device.
Response
Parameters
Byte 0
Return code (Page 51)
Byte 1
• 0: queried the scene membership in CM 1xDALI.
• 1: queried the scene membership on the device.
Byte 2
Scene level
Byte 3 Show the scene color type.
• 16#10: color xy-coordinate
• 16#20: color temperature
• 16#00: the control gear type is not type 8 (color control)
• Other values: scene color type is unknown.