Siemens SIMATIC ET 200SP CM 1xDALI - Query Control Gear Groups; Add Control Gear to Groups

CM 1xDALI command list
3.4 Configuration
ET 200SP CM 1xDALI Communication Model Description
38 Programming Manual, 12/2019, A5E47581955-AA
3.4.7 Query control gear groups
Description
Use this CM command to query the group membership information of a control gear.
Command ID
27
Input Param-
eters
Byte 0
Short address of the control gear
Byte 1 Query actual device flag.
• 0: query the group membership information saved in CM 1xDALI.
• 1: query the group membership information on the device.
Response
Parameters
Byte 0 Return code (Page 51)
Byte 1
• 0: queried group membership in CM 1xDALI.
• 1: queried group membership on the device.
Byte 2 Membership of group 0 to 7:
Each bit indicates one group. For example, Bit 0 is for group 0, bit 1 is
for group 1.
• 1: control gear is added to this group.
• 0: control gear is not in this group.
Byte 3 Membership of group 8 to 15:
Each bit indicates one group. For example, Bit 0 is for group 8, bit 1 is
for group 9.
• 1: control gear is added to this group.
• 0: control gear is not in this group.
3.4.8 Add control gear to groups
Description
Use this CM command to add the control gear to some groups.
Command ID
28
Input Param-
eters
Byte 0
Short address of the control gear
Byte 1 Add to group 0 to 7.
Each bit indicates one group. For example, Bit 0 is for group 0; bit 1 is
for group 1.
• 1: add to this group
• 0: no action
Byte 2 Add to group 8 to15.
Each bit indicates one group. For example, Bit 0 is for group 8; bit 1 is
for group 9.
• 1: add to this group
• 0: no action
Response
Parameters
Byte 0 Return code (Page 51)