Siemens SIMATIC ET 200SP CM 1xDALI - Diagnostic function blocks

CM 1xDALI command list
3.7 Return code and control status
ET 200SP CM 1xDALI Communication Model Description
Programming Manual, 12/2019, A5E47581955-AA
53
Bit
Type 1 (emergency)
Type 2 (discharge)
Type 3 (halogen)
type 4 (incandescent)
5 Duration test maxi-
mum delay exceeded
Reserved Thermal shut down Thermal shut down
6 Function test failed Lamp voltage out of
spec
Thermal overload Thermal overload
7 Duration test failed Lamp cycling failure Reference measure-
ment failed
Reference measure-
ment failed
Bit
Type 5 (emergency)
Type 6 (discharge)
Type 7 (halogen)
type 8 (incandescent)
0 Output fault detected Short circuit Load error XY-coordinate color
point out of range
1 Reserved Open circuit Error detection in hold
off
Color temperature out
of range
2 Reserved Load decrease Last threshold acted
upon ‘00’ up switch-on
’01’ up switch-off
‘10’ down switch on
‘11’ down switch off
Auto calibration run-
ning
3 Reserved Load increase Auto calibration suc-
cessful
4 Reserved Current protector
active
Reserved Color type XY-
coordinate active
5 Reserved Thermal shut down Reserved Color type color tem-
perature active
6 Reserved Thermal overload Reserved Color type primary N
active
7 Reserved Reference measure-
ment failed
Reference measure-
ment failed
Color type RGBWAF
active
Input device status
Bit
Description
0 Input device error
1
Quiescent mode
2 Short address is mask (0xFF).
3
Application active
4
Application controller error
5
Power cycle seen
6
Reset state
7
Reserved