Siemens SIMATIC IPC MD-34A User Manual

Firmware/BIOS description
7.2 Configure firmware
MD-34A
78 Operating Instructions, 08/2023, A5E52427535-AA
Firmware setting Value Setting in deliv-
ery state
Meaning
Boot URI
A new boot option will be created ac-
cording to this Boot URI.
Create boot op-
tion
7.2.5 "Exit" tab
Exit the Setup utility. You have the following options for saving or discarding the changes
you made:
Calling "Exit"
Choose: "Setup Utility (Page 71)" > "Exit".
Firmware setting
Meaning
Exit Saving Changes All changes are saved.
The device is restarted with the changed firmware settings.
Save Change Without Exit
All changes are saved.
Setup utility remains open.
Exit Discarding Changes
Setup Utility is closed.
All changes are discarded.
Load Optimal Defaults
The firmware settings are reset to the safe default values.
The delivery state is restored.
NOTICE:
All current firmware settings are overwritten.
Load Custom Defaults
The user-specific profile with the user-specific firmware settings is
loaded.
Requirement:
The firmware settings were previously saved as user-specific profile
with "Save Custom Defaults".
NOTICE:
All current firmware settings are overwritten when loading the user-
specific profile with "Load Custom Defaults".
Save Custom Defaults
The current firmware settings are saved as a user-specific profile (see
also "Load Custom Defaults").
Discard Changes
All changes to the firmware settings are discarded.

Siemens SIMATIC IPC MD-34A Specifications

General

Brand	Siemens
Model	SIMATIC IPC MD-34A
Category	Industrial Equipment
Language	English