Testing the configuration of the SMTP server
1. Configure recipients
– Click the "Recipient" tab.
– Select the desired SMTP server under "SMTP server".
– Enter the desired address under "E-mail address of the SMTP recipient".
– Click the "Create" button. A new entry is generated in the table. The setting "Send" is
activated by default.
2. Send test e-mail
– Click the "General" tab.
– Click the "Test" button next to the SMTP server entry. The device sends to every
configured recipient
– Check the test result. If sending was not successful, the message contains possible
causes.
4.5.6.2 Recipient
On this page, you specify who receives an e-mail when an event occurs.
Description
The page contains the following boxes:
● SMTP Server
Specify the SMTP server via which the e-mail is sent.
● Email address of the SMTP recipient
Enter the e-mail address to which the device sends an e-mail.
Configuring with Web Based Management
4.5 "System" menu
SCALANCE S615 Web Based Management
Configuration Manual, 11/2019, C79000-G8976-C388-08 145
To Next Page
Loading...
