4.7.2.2 Port Based VLAN
Processing received frames
On this WBM page, you specify the configuration of the port properties for receiving frames.
Description
Table 1 has the following columns:
● All ports
Shows that the settings are valid for all ports of table 2.
● Priority / Port VID / Acceptable Frames / Ingress Filtering
In the drop-down list, select the setting for all ports. If "No Change" is selected, the entries
of the corresponding column in table 2 remain unchanged.
● Copy to Table
If you click the button, the setting is adopted for all ports of table 2.
Table 2 has the following columns:
● Port
Shows the available ports.
● Priority
Select the required priority assigned to untagged frames.
The CoS priority (Class of Service) used in the VLAN tag. If a frame is received without a tag,
it will be assigned this priority. This priority specifies how the frame is further processed
compared with other frames.
There are a total of eight priorities with values 0 to 7, where 7 represents the highest priority
(IEEE 802.1p Port Priority).
● Port VID
Select the required VLAN ID. Only VLAN IDs defined in "VLAN > General" can be selected.
If a received frame does not have a VLAN tag, it has a tag with the VLAN ID specified here
added to it and is sent according to the rules at the port.
Configuring with Web Based Management
4.7 "Layer 2" menu
SCALANCE S615 Web Based Management
220 Configuration Manual, 11/2019, C79000-G8976-C388-08
To Next Page
Loading...
Need help?
General
