Description
The page contains the following boxes:
● Trap Receiver Address
Enter the IP address, the FQDN (Fully Qualified Domain Name) or the host name of the
station to which the device sends SNMP traps. You can specify up to ten different recipients
servers.
The table has the following columns:
● Select
Select the row you want to delete.
● Trap Receiver Address
If necessary, change the IP address, the FQDN (Fully Qualified Domain Name) or the host
name of the stations.
● Trap
Enable or disable the sending of traps. Stations that are entered but not selected do not
receive SNMP traps.
Procedure
Creating a trap entry
1. In "Trap Receiver Address", enter the IP address, the FQDN or the host name of the station
to which the device will send traps.
2. Click the "Create" button to create a new trap entry.
3. Select the check box in the required row "Trap".
4. Click the "Set Values" button.
Deleting a trap entry
1. Enable "Select" in the row to be deleted.
2. Click the "Delete" button. The entry is deleted.
Configuring with Web Based Management
4.5 "System" menu
SCALANCE S615 Web Based Management
150 Configuration Manual, 11/2019, C79000-G8976-C388-08
To Next Page
Loading...
Need help?
General
