Siemens SIMATIC NET SCALANCE SC-600 - Page 121

Configuring with Web Based Management
4.4 "System" menu
SCALANCE SC-600 Web Based Management (WBM)
Configuration Manual, 10/2021, C79000-G8976-C475-03
121
• Min. TLS version
Specify the minimum TLS version to be used.
• Default Login Page
Specify the login page with which the WBM starts by default.
– Firewall
Logging into the WBM page for dynamic firewall.
– Configuration
Logging into the WBM.
• SMTP Client
Enable or disable the SMTP client. You can configure other settings in "System >
SMTP Client".
• Syslog Client
Enable or disable the Syslog client. You can configure other settings in "System >
Syslog Client".
• DCP Server
Specify whether the device can be accessed with DCP (Discovery and Configuration
Protocol):
– "-" (disabled)
DCP is disabled. Device parameters can neither be read nor modified.
– Read/Write
With DCP, device parameters can be both read and modified.
– Read Only
With DCP, device parameters can be read but cannot be modified.
• Time
Select the setting from the drop-down list. The following settings are possible:
– Manual
The system time is set manually. You can configure other settings in "System >
System Time > Manual Setting".
– SIMATIC Time
The system time is set via a SIMATIC time source. You can configure other
settings in "System > System Time > SIMATIC Time Client".
– SNTP Client
The system time is set via an SNTP server. You can configure other settings in
"System > System Time > SNTP Client".
– NTP Client
The system time is set via an NTP server. You can configure other settings in
"System > System Time > NTP Client".