Siemens SIMATIC RF615R - Page 182

Programming via XML interface
10.3 XML commands
SIMATIC RF600
182 Configuration Manual, 11/2018, C79000-G8976-C386-07
Parameter
Parameter
Type
Values
Description
value_id Decimal value
0...9
0...4294967295 Unique command identifier
value_
sourceName
Text -- Read point name
The name is specified using the WBM
(refer to the section "The "Settings -
Read points" menu item (Page 52
)").
In the standard configuration, there is
only one read point with the name
"Readpoint_1".
value_duration Decimal value
0...9
0...65535 Optional
Period of time for which the selected
read point should read transponders.
If a value "0" is set or the parameter is
empty, the transponders are returned
immediately to the "Observed" status
without a time or a read cycle being
executed.
This behavior is particularly interesting
when the data source is controlled by
other points (e.g. inputs).
value_unit Fixed values Time
Count
Optional
Specifies the unit for the duration.
• Time = time in milliseconds
• Count = number of inventories
If no value is set, the duration is speci-
fied in milliseconds.
value_tagID Hexadecimal
value
0...9, A...F
-- EPC-ID in "RAW Hex Data Format".
Example of a 96-bit EPC-ID:
3005FB63AC1F3681EC880468
For additional information, refer to the
"EPC Global Specification".
value_tagPC Hexadecimal
value
0...9, A...F
-- Optional
Tag PC (Protocol Control)
16-bit value represented by four hexa-
decimal characters.
Example:
The value "1234" corresponds to the
binary value "0001.0010.0011.0100".
value_utcTime Time -- Optional
UTC time stamp (Universal Time Co-
ordinated) in ISO 8601 format:
yyyy-MM-ddTHH:mm:ss.fffzzz
e.g.: 2009-12-24T18:34:56.929+00:00.
value_
antennaName
Fixed values Antenna01
Antenna02
Antenna03
Antenna04
Optional
Name of the antenna