EasyManua.ls Logo

Siemens Simatic S7-1500 / ET 200MP - Page 343

Siemens Simatic S7-1500 / ET 200MP
385 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
Technical specifications
16.1 Standards, approvals and safety instructions
Automation system
342 System Manual, 01/2023, A5E03461182-AK
T-CPUs:
According to EN 60079-15 (Electrical apparatus for potentially explosive atmospheres - Part
15: Type of protection "n") and EN IEC 60079-0 (Electrical apparatus for potentially explosive
gas atmospheres - Part 0: General requirements).
II 3 G Ex nA IIC T4 Gc
DEKRA 16ATEX0092 X
OR
According to EN IEC 60079-7 (Electrical apparatus for potentially explosive atmospheres - Part
7: Increased safety "e") and EN IEC 60079-0 (Electrical apparatus for potentially explosive gas
atmospheres - Part 0: General requirements).
II 3 G Ex ec IIC T4 Gc
DEKRA 21ATEX0046 X
Special conditions in hazardous areas:
The equipment shall only be used in an area of not more than degree of pollution 2, as
defined in EN 60664-1.
The equipment shall be installed in a suitable enclosure providing a degree of protection
not less than IP54 in accordance with EN IEC 60079-0. The ambient conditions must be
taken into consideration for use.
Provisions shall be made to prevent the nominal voltage from being exceeded by transient
disturbances of more than 119 V.

Table of Contents

Other manuals for Siemens Simatic S7-1500 / ET 200MP

Related product manuals