EPROM/EEPROM OPERA
TION
4-8
Hardware
and Installation User Manual
4.4 PROGRAMMING THE EEPROM
To
program the EEPROM, you first must enter the
RLL program into the PLC.
Verify
that this program is correct and continue with the steps listed below
.
1. Make certain that the battery enable dipswitch is ON, and that the
jumper
pins are set for EEPROM.
2.
Set the PLC to PROGRAM mode.
3. Select
Auxiliary Function 84 in your
programming unit. Use the “Copy”
option to copy your RLL program to the EEPROM. The programming
unit
displays messages indicating the progress of the copy operation.
The PLC completes all current and pending communication processes
and turns off the communication ports before beginning the copy
operation.
NOTE
The TI525/TI535 PLCs copy data to the EEPROM
very rapidly. The entire copy process takes
approximately
5 seconds or less.
The PLC enters PROGRAM mode when the copy process is completed.
Artisan Scientific - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisan-scientific.comArtisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com
To Next Page
Loading...
Need help?
General
