Compartment identification
9.3 Operating compartment identification
SIMOCODE pro
166 System Manual, 05/2019, A5E40507475002A/RS-AD/004
Messages
You can check the states of the initialization module by the following events (in the
""Commissioning → Faults, warnings, event" dialog box of the "SIMOCODE ES (TIA Portal)"
software:
● Initialization module write-protected
● Initialization module write-protected, parameter changes not allowed
● Initialization module identification data write-protected
● Initialization module read in
● Initialization module programmed
● Initialization module cleared.
See Alarm, fault, and system events for compartment identification (Page 171).
To Next Page
Loading...
