Commissioning, service, troubleshooting
13.2 Commissioning
SIMOCODE pro
System Manual, 05/2019, A5E40507475002A/RS-AD/004
273
13.2.4.3 Set the time manually after switch-on or recovery of the supply voltage
Setting the timer with SIMOCODE ES
If the internal realtime clock of the devices is not automatically synchronized via NTP, you
can make the setting manually with SIMOCODE ES.
To do so, follow these steps:
Set the time manually after switch-on or recovery of the supply voltage
Establish an online connection.
Set the device-internal real time clock via "Commissioning → Command → Set time (= PC time in UTC)"
To Next Page
Loading...
