EasyManua.ls Logo

Siemens SIMOCODE pro V MR

Siemens SIMOCODE pro V MR
408 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
Introduction
1.11 Modules, interfaces, configuration options
SIMOCODE pro
System Manual, 05/2019, A5E40507475002A/RS-AD/004
27
Additional control programs (star-delta starters, Dahlander starters, pole-changing starters,
soft starters, each program also possible in combination with reversing starter, solenoid
valve and positioner) are integrated in SIMOCODE pro V High Performance units. The
SIMOCODE pro V device type is also particularly versatile. Its functionality can be expanded,
if required, for example:
The number and type of binary inputs and outputs can be increased in stages and
adapted.
A current/voltage measuring module can be used for additional voltage measurement and
for monitoring power-related measured values (power management).
A temperature module enables the evaluation of several analog temperature sensors.
A ground-fault detection system can be integrated together with a summation current
transformer.
An analog module extends the system by additional analog inputs and outputs, for
example, for fill-level or flow-rate monitoring.
An operator panel with display (OPD) is available as an alternative to the standard
operator panel (OP)
(restriction in the case of the SIMOCODE pro V PB: from version *E03*).
A special current/voltage measuring module for dry-running protection of centrifugal pumps
in hazardous areas by active power monitoring can be used in combination with the following
high performance devices with PTB 18 ATEX 5003:
SIMOCODE pro V PB from version *E16*
SIMOCODE pro V PN from version *E13*
SIMOCODE pro V EIP from version *E04*
SIMOCODE pro C and SIMOCODE pro S are upwardly-compatible with SIMOCODE pro V.
This means you can combine different series in your plant according to functional
requirements.
Depending on functional requirements, the systems can be used simultaneously in a
low-voltage switchboard without any problems and without any additional effort.
Parameterization of SIMOCODE pro C or SIMOCODE pro S can be transferred without a
problem.

Table of Contents

Related product manuals