Siemens SIMOCODE pro V MR

Table of contents
SIMOCODE pro
4 System Manual, 05/2019, A5E40507475002A/RS-AD/004
8 Description of system components ........................................................................................................ 81
8.1 Basic units (BU) ..................................................................................................................... 81
8.2 Operator panel (OP) .............................................................................................................. 85
8.3 Operator panel with display ................................................................................................... 88
8.3.1 Description of the operator panel with display ....................................................................... 88
8.3.2 Operator controls and display elements of the operator panel with display .......................... 92
8.3.3 Menu of the operator panel with display ................................................................................ 94
8.3.3.1 Timing charts .......................................................................................................................... 94
8.3.3.2 Displays of the operator panel with display ......................................................................... 109
8.3.3.3 Read and adapt main display .............................................................................................. 112
8.3.3.4 Display of measured values in the measured values display .............................................. 115
8.3.3.5 Motor protection and motor control status ........................................................................... 117
8.3.3.6 Display of statistical and maintenance-relevant information on the
statistics/maintenance display ............................................................................................. 119
8.3.3.7 Status display for fieldbus communication ........................................................................... 120
8.3.3.8 Displays the current status of all device I/Os ....................................................................... 122
8.3.3.9 Parameters ........................................................................................................................... 124
8.3.3.10 Adapt display settings .......................................................................................................... 126
8.3.3.11 Resetting, testing and parameterizing via commands ......................................................... 129
8.3.3.12 Displaying all pending messages ......................................................................................... 130
8.3.3.13 Displaying all pending warnings........................................................................................... 130
8.3.3.14 Displaying all pending faults ................................................................................................ 130
8.3.3.15 Reading the device's internal error buffer ............................................................................ 130
8.3.3.16 Reading the device's internal event memory ....................................................................... 131
8.3.3.17 Identification of the motor feeder and the SIMOCODE pro components............................. 132
8.4 Current measuring modules (IM) for the SIMOCODE pro C, SIMOCODE pro S, and
SIMOCODE pro V device series .......................................................................................... 133
8.5 Current / voltage measuring modules (UM, UM+) for the SIMOCODE pro V
High Performance device series ..........................................................................................
135
8.
6 Decoupling module (DCM) for 1st generation current/voltage measuring modules
(e.g. 3UF711.1AA000) ......................................................................................................... 142
8.7 Spectrum of the expansion modules ................................................................................... 146
8.8 Digital module (DM) ............................................................................................................. 147
8.9 Fail-safe digital module (DM-F) ............................................................................................ 148
8.10 Analog module (AM) ............................................................................................................ 151
8.11 Ground-fault module (EM) ................................................................................................... 152
8.12 Temperature module (TM) ................................................................................................... 153
8.13 Multifunction module ............................................................................................................ 154
8.14 Configuration information for SIMOCODE pro V when using an older basic unit ............... 155
8.15 Configuration notes for use of a SIMOCODE pro V MR and SIMOCODE pro V EIP
basic unit .............................................................................................................................. 158