Siemens SIMOTION D4x5 Series - Safety Information

You might need to access the information provided on the type plate after the CBE30 has been
mounted.
Because the type plate is mounted on the underside of the CBE30, we recommend
that you note the serial number before mounting it.
Note
The
contents of the individual type plate fields of the CBE30 may differ from those described
in this manual (e.g. updated product status, approvals and markings not yet issued, etc.).
MAC address
A second plate for the MAC address of the Ethernet interfaces is attached to the top side of
the board:
0$&DGGUHVV
Figure 7-10 CBE30 MAC address
This plate is only visible when the CBE30 has been removed. You need the MAC address to
assign an IP address.
Note
The MAC address is affixed to the top side of the CBE30, behind the RJ45 sockets.
7.5.3 Safety Information
NOTICE
Damage to the CBE30 caused by electric fields or electrostatic discharge
Option boards are ESD-sensitive components.
De-energize the SIMOTION D4x5 device before inserting or removing the option board.
SIMOTION D4x5 is in a de-energized state when all the LEDs are OFF.
Comply with the ESD rules.
See also
ESD guidelines
(Page 123)
Supplementary system components
7.5 CBE30 communication board Ethernet
SIMOTION D4x5
Manual, 04/2014 109