Siemens SINAMICS G120D Series - What Do You Need for Communication Via PROFINET

Adapt fieldbus configuration
6.3 Communication via PROFINET
Further information on PROFINET can be found on the Internet using the following links:
– General information about PROFINET can be found at Industrial Communication
(
http://www.automation.siemens.com/mcms/automation/en/industrial-
communications/profinet/Pages/Default.aspx).
– The configuration of the functions is described in the PROFINET system description
(http://support.automation.siemens.com/WW/view/en/19292127
) manual.
This manual describes the control of the inverter using primary control. How to access the
inverter as an Ethernet station is described in the Fieldbus function manual (Page 316) in the
section "The inverter as an Ethernet station".
6.3.1
What do you need for communication via PROFINET?
Check the communication settings using the following table. If you answer "Yes" to the
questions, you have correctly set the communication settings and can control the inverter via
the fieldbus.
Questions
Answer/description
Example
Is the inverter correctly connected to
the bus network?
See: Integrating inverters into
PROFINET (Page 108)
Do the IP address and device name
in the inverter and controller match?
See Configuring communication
to the control (Page 108)
Refer to manuals for your
inverter, fieldbus function
manual (Page 316)
Is the same telegram set in the in-
verter as in the higher-level control-
ler?
Setting the telegram in the con-
trol
Are the signals that the inverter and
the controller exchange via
PROFINET correctly interconnected?
Interconnection in the inverter in
conformance with PROFIdrive,
see: PROFIdrive profile for
PROFIBUS and PROFINET
(Page 92)
Converter with control units CU240D-2
Operating Instructions, 04/2015, FW V4.7.3, A5E34262100B AB
107