Backing up data and series commissioning
8.2 Backing up and transferring settings using STARTER
Backing up and transferring settings using STARTER
With the supply voltage switched on,
you can transfer the converter settings
from the converter to a PG/PC, or the
data from a PG/PC to the converter.
dition is that you have a
commissioning tool on your PG/PC.
You will find more information on PC tools in section: Commissioning tools (Page 25).
→
PC/PG
Procedure with STARTER
To back up the settings with STARTER, proceed as follows:
1. Go online:
.
2. Click the "Download project to PG" button:
.
3. Save the project:
.
4. Wait until STARTER reports that data backup has been completed.
5. Go offline:
.
You have backed up the settings with STARTER.
Procedure with Startdrive
To back up the settings with Startdrive, proceed as follows:
1. Go online.
2. Select "Online" > "Upload device to PG/PC."
3. Back up the project with "Project" > "Save."
4. Wait until Startdrive reports that data backup has been completed.
5. Go offline.
You have backed up the settings with Startdrive.
Converter with control units CU240D-2
Operating Instructions, 04/2015, FW V4.7.3, A5E34262100B AB
225
To Next Page
Loading...
