Siemens SINAMICS G120D Series - Interconnecting Signals in the Inverter; Fundamentals

Appendix
A.4 Interconnecting signals in the inverter
A.4
Interconnecting signals in the inverter
A.4.1
Fundamentals
The following functions are implemented in the converter:
● Open-loop and closed-loop control functions
● Communication functions
● Diagnosis and operating functions
Every function comprises one or several blocks that are interconnected with one another.
Figure A-2 Example of a block: Motorized potentiometer (MOP)
Most of the blocks can be adapted to specific applications using parameters.
You cannot change the signal interconnection within the block. However, the interconnection
between blocks can be changed by interconnecting the inputs of a block with the appropriate
outputs of another block.
The signal interconnection of the blocks is realized, contrary to electric circuitry, not using
cables, but in the software.
Figure A-3 Example: Signal interconnection of two blocks for digital input 0
Converter with control units CU240D-2
304 Operating Instructions, 04/2015, FW V4.7.3, A5E34262100B AB