Advanced commissioning
7.2 Inverter control
Switching over the inverter control (command data set)
In some applications, it must be possible to switch over the master control for operating the
inverter.
Example: The motor is to be operable either from a central control via the fieldbus or from a
local control box via the terminal strip.
This means that you can set the inverter co
n-
trol in various ways and toggle between the
settings. For instance, as described above,
the inverter can either be
operated via a
fieldbus or via the terminal strip.
The settings in the inverter, which are a
s-
signed to a specific master control, are termed
the command data set.
You select the command data set using parameter p0810. To do this, you must interconnect
parameter p0810 with a control command of your choice, e.g. a digital input.
Figure 7-7 Example for the various command data sets
Converter with control units CU240D-2
Operating Instructions, 04/2015, FW V4.7.3, A5E34262100B AB
127
To Next Page
Loading...
