Siemens SINAMICS G120D Series - Switching Units with STARTER

Advanced commissioning
7.7 Application-specific functions
7.7.2.4
Switching units with STARTER
Precondition
The inverter must be in the offline mode in order to change over the units.
STARTER shows whether you change settings online in the inverter or change offline in the
PC (
/ ).
You switch over the mode using the adjacent
buttons in the menu bar.
Procedure
To change over the units with STARTER, proceed as follows:
1. Select the configuration
2. Go to the "Units" tab in the configuration screen form to change over the units
3. Changing over the system of units
4. Select process variables of the technology controller
5. Adapting to the line supply
6.
Save your settings.
7.
Go online.
The inverter signals that
offline, other units and
pr
ocess variables are set
than in the inverter itself.
8.
Accept these settings in
the inverter.
You have changed over the units.
Converter with control units CU240D-2
Operating Instructions, 04/2015, FW V4.7.3, A5E34262100B AB
179