Siemens SINAMICS G120D Series - Page 271

Alarms, faults and system messages
10.3 Status LED overview
Explanation of status LEDs
An explanation of the various states indicated by the LEDs are given in the tables below.
Table 10- 1 Description of general status LEDS
RDY
BF
Description of function
GREEN - On
-
Ready for operation (no active fault)
GREEN - flashing slowly - Commissioning or reset of factory settings
RED - on
Off
Firmware update in progress
RED - flashing slowly
RED - flashing slowly
Firmware updated is complete - power ON reset required
RED - flashing quickly
-
General fault condition
RED - flashing quickly
RED - On
Fault occurred during firmware update
RED - flashing quickly
RED - flashing quickly
Incorrect settings, incompatible firmware or incorrect memory card
Table 10- 2 Description of PROFIBUS communications LED
BF
Description of function
Off
Cyclic data exchange (or PROFIBUS not in use - p2030 = 0)
RED - flashing slowly
Bus fault - configuration fault
RED - flashing quickly Bus fault:
- no data exchange
- baud rate search - cannot detect the correct baud rate
- no connection - the connection between the Inverter and PLC has been lost
Table 10- 3 Description of SAFE LED
SAFE
Description of function
YELLOW - On
One or more safety functions are enabled - but not active
YELLOW - flashing slowly
One or more safety functions are active - no safety function faults have occurred.
YELLOW - flashing quickly
The Inverter has detected a safety function fault and initiated a stop response.
Table 10- 4 Description of PROFINET communications LEDS
ACT
LNK
Description of function
On/flashing
On
Link active and data transfer active if flashing
Off
Off
Link inactive with no data transfer
Table 10- 5 Description of Digital Input and Output LEDs
DI / DO
Description of function
On
Input/Output connected and working
Off
Input/Output not connected or has stopped working
Converter with control units CU240D-2
Operating Instructions, 04/2015, FW V4.7.3, A5E34262100B AB
271