Commissioning
5.4 Basic commissioning using a PC
Figure 5-4 "Accessible nodes" in Startdrive
6. When the USB interface is appropriately set, then the "Accessible nodes" screen form
shows the inverters that can be accessed.
Figure 5-5 Inverters found in STARTER
Figure 5-6 Inverters found in Startdrive
If you have not correctly set the USB interface, then the following "No additional nodes
found" message is displayed. In this case, follow the description below.
7. Proceed as follows:
• Select the inverter ☑.
• Press the "Accept" button.
• Accept the inverter into the project using the menu:
• "Online - Upload device as new station (hardware and
software)"
You have transferred an inverter accessible via the USB interface into your project.
Converter with control units CU240D-2
76 Operating Instructions, 04/2015, FW V4.7.3, A5E34262100B AB
To Next Page
Loading...
