Siemens SINAMICS V90 - Page 101

Task navigation
SINAMICS V-ASSISTANT Online Help
Operating Manual, 04/2017, A5E36618042-003
101
The definition for p29300 is as follows:
Bit 6
Bit 5
Bit 4
Bit 3
Bit 2
Bit 1
Bit 0
EMGS
TSET
SPD1
TLIM1
CCWL
CWL
SON
For example, if you set p29300 = 1 to force the signal SON to a logical high signal, DI1 can
then be assigned to other desired signals.
Note
The parameter p29300 has higher priority than the DIs.
The bit 6 of p29300 is used for emergency stop. You are not allowed to modify it
when the
drive is in "S ON" state.
Wiring
The digital inputs support both PNP and NPN types of wirings. You can find detailed
information from the following diagrams:
NPN wiring
PNP wiring