Siemens SINAMICS V90 - Configuring Inputs;Outputs; Assigning Digital Inputs

Task navigation
SINAMICS V-ASSISTANT Online Help
Operating Manual, 04/2017, A5E36618042-003
75
4.3.6
Configuring inputs/outputs
Three sub-functions are available as follows:
● Assigning digital inputs (Page 75)
● Assigning digital outputs (Page 76)
● Assigning analog outputs (V90 PTI only) (Page 77)
4.3.6.1
Assigning digital inputs
You can assign digital inputs on the following panels:
● Assigning digital inputs for V90 PN
A total of four signals can be freely linked to digital inputs, for more information, see
Section "DIs (Page 94)".
Click the cells with white background in the table. Two options are displayed in the drop-
down list:
Assign
and
Cancel
. Select
"Assign"
to link the digital input with the
corresponding signal. Then the current row displays grey. Otherwise, select
"Cancel"
to
release the link. The current row then displays white.
● Assigning digital inputs for V90 PTI
A total of 28 signals can be freely linked to digital inputs except for DI9 and DI10 linked
with E_Stop and C_Mode signals. For more information, see Section "DIs (Page 97)".
Click the cells with white background in the table. Two options are displayed in the drop-
down list:
Assign
and
Cancel
. Select
"Assign"
to link the digital input with the
corresponding signal. Then the current row displays grey. Otherwise, select
"Cancel"
to
release the link. The current row then displays white.