Task navigation
SINAMICS V-ASSISTANT Online Help
Operating Manual, 04/2017, A5E36618042-003
47
Jog function is only available in online mode. You can configure this function on the following
panel:
● To start the Jog function, enter the Jog speed first. Click , then
the following warning appears:
Click
and run the drive counter-clockwise/clockwise by clicking the following
two buttons respectively:
Then the actual speed, actual torque, actual current and actual utilization are displayed.
● To stop the Jog function, click
in the following window and
SINAMICS V-ASSISTANT releases the control priority.
Note
The Jog speed can not be too fast. Otherwise, the machine axes can get out of control due
to possible communication delay.
To Next Page
Loading...
