Siemens SINAMICS V90 - Tools -> Reset Absolute Encoder; Tools -> Factory Default

To Next Page

To Previous Page

User interface

3.3 Menu bar

SINAMICS V-ASSISTANT Online Help

Operating Manual, 04/2017, A5E36618042-003

Click and the drive is restarted successfully.

3.3.5.3

Tools -> Reset absolute encoder

In online mode, if you have connected SINAMICS V-ASSISTANT to a motor with an absolute

encoder, you can use this menu command to set the current position of the absolute encoder

as the reference point.

3.3.5.4

Tools -> Factory default

Online

Select this menu command and the following reminder appears:

Other manuals for Siemens SINAMICS V90