Siemens SINAMICS V90 - 3 User Interface; Working Modes

SINAMICS V-ASSISTANT Online Help
Operating Manual, 04/2017, A5E36618042-003
19
User interface
3
3.1
Working modes
When you start SINAMICS V-ASSISTANT, the following window appears for you to select a
working mode:
The functions of SINAMICS V-ASSISTANT vary with the working modes.
Online mode
SINAMICS V-ASSISTANT communicates with the target drive, which is connected with PC
by a USB cable.
If you select the online mode, a list of all connected drives are displayed. Select the target
drive and click the following button.
SINAMICS V-ASSISTANT automatically creates a new project to save all parameter settings
from the target drive and enters the main window.
Note
If SINAMICS V
-ASSISTANT fails to detect the connected drive(s) immediately, please wait
for a while and then plug in the USB cable again.