Siemens SINAMICS V90 - Project -> Language; Project -> Exit; Edit Menu; Edit -> Cut

User interface
3.3 Menu bar
SINAMICS V-ASSISTANT Online Help
30 Operating Manual, 04/2017, A5E36618042-003
3.3.2.6
Project -> Language
Online mode/offline mode
You can use this menu command to switch the user interface language as desired. The
default languages of SINAMICS V-ASSISTANT are English and Chinese. For installation
packages of additional languages, visit this address (http://www.siemens.com/sinamics-v-
assistant). After you download the desired installation package to your PC and run it, you
can switch the interface language to the corresponding one.
3.3.2.7
Project -> Exit
Online mode/offline mode
You can use this menu command to exit from SINAMICS V-ASSISTANT directly.
3.3.3
Edit menu
This menu contains commands for cutting, copying and editing the parameter values or
technical data of the motor and drive.
● Cut (Page 30)
● Copy (Page 31)
● Paste (Page 31)
3.3.3.1
Edit -> Cut
This command deletes the selected objects, for example, the parameter values from the user
interface, and then copies them to the clipboard.
Alternatively, you can use
from the toolbar.
Note
This menu command can only be used to modify the values in
"Viewing all parameters
(Page
87)".