Task navigation
SINAMICS V-ASSISTANT Online Help
92 Operating Manual, 04/2017, A5E36618042-003
DO1~DO6 Every digital output can be freely linked with either of the
DO1~DO2 Every digital output can be freely linked with either of the
For more information, see Section "Digital inputs/outputs (DIs/Dos) (Page 94)".
⑥
Clicking this button enables DO simulation. If you desire
to disable this function, click the following button:
⑦
Signal is enabled Indicates that high-voltage (or logic 1) is on the digital
Signal is disabled Indicates that low-voltage (or logic 0) is on the digital
input/output.
Signal is forcedly set
Indicates that the status of the assigned signal is forcedly
DO is reversed Indicates that the logic of the DO is reversed.
After the DO is reversed, a "/" appears in front of the DO
This function is unavailable but can be displayed in offline mode.
The status of each indicator and analog value is updated every 0.5 s.
Signal P_TRG in PTI control mode is reserved for future use.
You can change the signal link as desired. For more information, see Section
"Configuring inputs/outputs (Page 75)".
To Next Page
Loading...
