Siemens SINUMERIK 808D ADVANCED - Page 483

Parameter Manual
Operating Instructions, 08/2013, 6FC5397-8EP40-0BA0
483
IS_SD_MAX_PATH_ACCEL
MD 42502, 315
IS_SD_MAX_PATH_JERK
MD 42512, 316
IS_UNIPOLAR_OUTPUT
MD 30134, 193
J
JOG_AND_POS_JERK_ENABLE
MD 32420, 225
JOG_AND_POS_MAX_JERK
MD 32430, 226
JOG_CIRCLE_CENTRE
MD 42690, 318
JOG_CIRCLE_END_ANGLE
MD 42694, 320
JOG_CIRCLE_MODE
MD 42692, 319
JOG_CIRCLE_RADIUS
MD 42691, 318
JOG_CIRCLE_START_ANGLE
MD 42693, 319
JOG_CONT_MODE_LEVELTRIGGRD
MD 41050, 302
JOG_FEED_PER_REV_SOURCE
MD 42600, 317
JOG_GEOAX_MODE_MASK
MD 42996, 323
JOG_INC_MODE_LEVELTRIGGRD
MD 11300, 65
JOG_INCR_SIZE_TAB
MD 11330, 66
JOG_INCR_WEIGHT
MD 31090, 210
JOG_INCR_WEIGHT_TRAFO
MD 31092, 210
JOG_MODE_MASK
MD 10735, 47
JOG_POSITION
MD 43320, 327
JOG_REV_IS_ACTIVE
MD 41100, 303
JOG_REV_SET_VELO
MD 41120, 305
JOG_REV_VELO
MD 32050, 215
JOG_REV_VELO_RAPID
MD 32040, 215
JOG_ROT_AX_SET_VELO
MD 41130, 305
Siemens Controls