Siemens SINUMERIK 840 Planning Guide

5 Configuring 11.92
5.24 FX 8 Presetting of tool size via EPROM
Program example with unconditional call
The tool size is to be preset in magazine 1 with FX 8: WZ-GR:EP. The data for the tool size
are stored on the EPROM in DB 100 from DW0. The function is started via input I 3.0. Output
"F" is set when no presetting is permitted, i.e. when one of the errors described above (3 - 7)
has occurred.
: A I 3.0 Edge for start
: AN F 104.2 Process ended
: S F 104.1 Process running
:
: L KB 1 Magazine number 1
: T FY 100
: L KB 100 DB 100
: T FY 101
: L KB 0
: T FW 102 1st Dw in DB EPROM
:DO FX 8
NAME : WZ-GR:EP
ST : F 104.1 Start signal
MANR : FY 100 Fictitious magazine
DBEP : FY 101 DB 100
DW-M : FW 102 1st DW in DB EPROM
VG-L : F 104.1 Process running
VG-B : F 104.2 Process ended
F : F 104.3 Error message
:
:BE
Note:
The start edge I 3.0 must be reset on "process ended" at the latest, otherwise a new start is
initiated.
5–104
© Siemens AG 1991 All Rights Reserved 6FC5 197-0AA40-1BP1
SINUMERIK 840/880 (PJ)

Siemens SINUMERIK 840 Specifications

General

Control Type	CNC
Axes	Up to 31
Display	TFT color display
PLC	Integrated
HMI	SINUMERIK Operate
Communication Interfaces	Ethernet, PROFIBUS, PROFINET
Type	CNC system
Programming Languages	G-code
Max Number of Channels	10
Operating Temperature	0 to 45 °C
Relative Humidity	Up to 95% (non-condensing)
Protection Class	IP54 (front panel)