11.92 4 Installation and Start-up
4 Installation and Start-up
The following instructions serve as a brief installation and start-up guide. A detailed guide is
envisaged.
Proceed as follows to install both the 880 tool management package and the operator
panel with tool data menu (milling example).
1. Enter machine data and format user memory, if necessary.
Relevant machine data:
(the default in the example applies to a machine with 2 magazines (1 active magazine,
1 background magazine), 1 TO area, 1 spindle)
NC MD 13 = 16 16 TO parameters
NC MD 210 = 1 1 TO area
NC MD 211 = 1 Initial D No. TO area 1
NC MD 1040 = 1 TO area 1 for channel 1
NC MD 5440.4 = 0 T word channel 1, binary output
NC MD 5440.6 = 0 H word channel 1, binary output
PLC MD 2000 = 4 *) Initial address, buffer
PLC MD 2001 = 10 Number of data words, buffer
PLC MD 2002 = 7 Number of DBs for user
PLC MD 2003 = 4 Number of DBs for reference data
PLC MD 2004 = 31 Initial address magazine 1
PLC MD 2005 = 10 Length of magazine
PLC MD 2006 = 1 Assigned TO area
PLC MD 2007 = 2 Assigned background magazine
(SINUMERIK 880/880 GA2 only)
PLC MD 2008 = 41 Initial address magazine 2
PLC MD 2009 = 10 Length of magazine
PLC MD 2010 = 1 Assigned TO area
PLC MD 2011 = 0 Assigned background magazine
(SINUMERIK 880/880 GA2 only)
PLC MD 2068 = 70 M function for tape start
PLC MD 2072 = 57 H group for special position
PLC MD 2075 = 1 Number of magazines assigned to a tool buffer
PLC MD 2076 = KY = 1,4 *) Spindle No./absolute address of spindle in
ˆ= KF = 260 tool buffer (conforms to DW No.)
PLC MD 7010.7 = 1 Tool management software runs on PLC 1
–––––––––––––––
*) If the operating example is to be used without any modifications, these presettings are obligatory.
© Siemens AG 1991 All Rights Reserved 6FC5 197-0AA40-1BP1 4–1
SINUMERIK 840/880 (PJ)
To Next Page
Loading...
Need help?
General
