4 Installation and Start-up 11.92
PLC MD 7012.3 = 1 Chain magazine
PLC MD 7013.7 = 1 With single tool
PLC MD 7013.6 = 1 Additional magazine assigned
PLC MD 7013.4 = 1 Magazine is assigned to a buffer
PLC MD 7013.2 = 1 Active magazine
PLC MD 7013.0 = 1 Submagazine available
PLC MD 7014.3 = 1 Chain magazine
PLC MD 7015.7 = 1 With single tool
PLC MD 7015.4 = 1 Magazine is assigned to a buffer
PLC MD 7015.2 = 0 Background magazine (SINUMERIK 880/880 GA2 only)
PLC MD 7015.0 = 1 Submagazine available
2. Transfer link list (FRBINDE 1 Var. B) to UMS.
3. The blocks of tool management package 1 are loaded from diskette into the PLC. FB 117
must be called in OB 20 to create the magazine table. In OB 1, FB 139 "Data distributor"
is called, which also generates DB 144 (required for the loading procedure). In addition,
FB 123 ("Tool selection on T change signal") must be called unconditionally in OB 1. If the
operating example is to be used, the relevant blocks must also be transferred to the PLC.
The operating example is called by FB 160 in OB 1.
Note:
The magazine table can only be extended by first deleting it and then creating it again.
4–2
© Siemens AG 1991 All Rights Reserved 6FC5 197-0AA40-1BP1
SINUMERIK 840/880 (PJ)
To Next Page
Loading...
Need help?
General
