3 Guidelines 11.92
3.2.2 Functions
3.2.2 Functions
The functions of the tool management software are divided up into two packages: Package 1
and package 2.
Package 1 includes the basic functions, i.e. those functions required for loading, tool search,
tool preparation and so forth. In addition, this package features two examples explaining its
usage: the MILLING and TURNING operating examples.
Package 2
1)
includes the functions required for managing the background magazine. From
release 02 onwards, the two packages support oversized data blocks (2044 DWs). In addition,
package 2 contains the function blocks necessary for generating a tool list.
List of the function blocks in package 1
FB 111: Neutral tool search
FB 112: Search for empty location without presetting
FB 114: Forward-search routine
FB 115: Backward-search routine
FB 116: Initialize when initial setting bit is set
FB 117: Create magazine table
FB 118: Tool size, standard
FB 119: Subroutine: Delete magazine
FB 120: Unloading via tape (SINUMERIK 880/880 GA2)
FB 120: Reserved (SINUMERIK 840/840C)
FB 121: Measuring
FB 122: Search for empty location with presetting
FB 123: Tool selection on T change signal
FB 124: T=Identification number (subroutine for FB 123)
FB 125: T=Locator number (subroutine for FB 123)
FB 126: T = Ident 2 (subroutine FB 123)
FB 127: Determine the assignment of a tool buffer to an NC channel/magazine (general
subroutine)
FB 128: Transfer
FB 129: Define P8/P9 (subroutine for FB 128) from release 1.2 onwards
FB 130: TO memory management
FB 131: Read PLC machine data words (general subroutine)
FB 132: Read PLC machine data bits (general subroutine)
FB 133: Direction selection
FB 134: Read/write TO data
FB 135: Provide D No. after tool change
FB 136: Read/write magazine data
FB 137: T word routing (up to software version 04 only)
_______
1) Package 2 applies to SINUMERIK 880/880 GA2 only
3–6 © Siemens AG 1991 All Rights Reserved 6FC5 197-0AA40-1BP1
SINUMERIK 840/880 (PJ)
To Next Page
Loading...
Need help?
General
