Modifications from version 01 to version 2.X of Tool Management for SINUMERIK 840
and SINUMERIK 840C.
The following functions have either been improved in version 03 or are new additions.
Cycles The cycle messages (load/unload via tape) are stored as an alarm file on
the diskette. These alarms must be transferred to the UMS. This makes it
possible to display alarms even on cycle inhibit.
As from NC software version 6.1, a program error is output if the
command "@714" is not programmed alone in a block. The tool
management cycles have been adapted to this.
The P0 memory is now available to the user for his own use.
Operating The milling example is now available in WS 800 A format.
example
Functions
Back-up on tape With FB 120 and cycle L944 it is now possible to back up the data for
when unloading individual tools or all the tools of a selected magazine on tape during tool
tools unloading. A loading program is generated with which the tool or tools can
again be loaded into the magazine (see also Section 2; operating
example).
Cartridge It is now possible, via loading and unloading lists, to signal the arrival of
handling transport cartridges to a machine magazine and to load/unload them (see
also Section 2).
Presetting This function supports cartridge handling. With the FX8 it is now possible
of tool size to set the tool size via the cartridge number in the magazine.
via EPROM
Delete With the user command D 70.7, it is now possible to delete the magazine
magazine for which this bit is set.
Symm. search It is now possible to search for empty locations symmetrically (s. FB 112).
for empty location
Altern. search The search sequence is selected in PLC MD m + 10, bit 5.
sequence
Tool size Tool management now supports tool sizes 1.1 to 7.7 (and any intermediate
combinations in the case of asymmetrical tools).
Expansion of (Applies to NC software version 6.1 only)
local buffer More machine data are available for tool management as from software
memory version 6.1. It has therefore been possible to increase the size of the local
tool buffer memory (see also Section 10).
Simulation Block FX7 enables D numbers for "Simulation" support.
Tool life/ It is now possible to enter the values for tool life and number of parts
Number of parts from P memory P8 when monitoring tool life and number of parts.
To Next Page
Loading...
Need help?
General
