Siemens SINUMERIK 840 Planning Guide

11.92 5 Configuring
5.5 FB 120 Unloading via tape
Save from to: Function code: 1
Unload magazines x to y, where the following restrictions must be observed.
1 < = x < = y <= 16
Parameters:
– First magazine (x) DB135 DR 18
– Last magazine (y) DB135 DL 18
Save chained: Function code: 2
Unloading of chained magazines starting from magazine x, the way in which
the magazines are chained is defined.
Case 1: Starting from magazine x up to the magazine to which no other
magazine is assigned.
Case 2: Starting from magazine x up to the magazine which is again
chained with magazine x.
Parameters:
– Starting magazine (x) DB135 DR 18
Save Hand marked: Function code: 3
The user can unload tools which have been marked manually
(operator panel) in DB153 with data bit 7.
Parameters:
None
© Siemens AG 1991 All Rights Reserved 6FC5 197-0AA40-1BP1 5–17
SINUMERIK 840/880 (PJ)

Siemens SINUMERIK 840 Specifications

General

Control Type	CNC
Axes	Up to 31
Display	TFT color display
PLC	Integrated
HMI	SINUMERIK Operate
Communication Interfaces	Ethernet, PROFIBUS, PROFINET
Type	CNC system
Programming Languages	G-code
Max Number of Channels	10
Operating Temperature	0 to 45 °C
Relative Humidity	Up to 95% (non-condensing)
Protection Class	IP54 (front panel)