Siemens SINUMERIK 840 Planning Guide

11.92 5 Configuring
5.11 FB 133 Direction selection
IST Actual position
Specification of the actual position (magazine locator No.) of the magazine.
SOPO Special position
Specification of the special position where the setpoint location is to be positioned.
ST Start signal
DR-R Clockwise rotation (descending locator number direction)
DR-L Counter-clockwise rotation (ascending locator number direction)
POSE Position reached
DIFF Difference between actual and setpoint position taking into consideration a special
position, if necessary.
F Error bit
"1" signal means: Actual and/or setpoint outside of the magazine limits or special
position > number of magazine locations.
© Siemens AG 1991 All Rights Reserved 6FC5 197-0AA40-1BP1 5–37
SINUMERIK 840/880 (PJ)

Siemens SINUMERIK 840 Specifications

General

Control Type	CNC
Axes	Up to 31
Display	TFT color display
PLC	Integrated
HMI	SINUMERIK Operate
Communication Interfaces	Ethernet, PROFIBUS, PROFINET
Type	CNC system
Programming Languages	G-code
Max Number of Channels	10
Operating Temperature	0 to 45 °C
Relative Humidity	Up to 95% (non-condensing)
Protection Class	IP54 (front panel)