Siemens SINUMERIK 840Di - Page 105

06.03
2.13 ADI4 (analog drive interface for 4 axes) (SW 09.01 and higher)
2-105
 Siemens AG, 2003. All rights reserved
SINUMERIK 840Di Manual (HBI) – 06.03 Edition
2.13 ADI4 (analog drive interface for 4 axes) (SW 09.01 and
higher)
2.13.1 Module
X1:
X2:
S2:
X3:
X4–2:
X5-1:
X4-1:
X5-2:
Encoder connection
for axis 1
DIL switch for setting the
PROFIBUS address
PROFIBUS connection
External power supply
24VDC
Analog setpoint outputs
$10V DC, axis 1–4
X6-2:
Connection for digital
input signals
X6-1:
Connection for digital
output signals
H1:
H2:
PW TMP
EXCH RDY
Connection for protective ground
screw M6
Diagnostic LEDs
Encoder connection
for axis 3
Encoder connection
for axis 2
Encoder connection
for axis 4
18
OFF ON
equivalent to
PROFIBUS address:
A
H
= 10
D
Fig. 2-33 Connection overview ADI4
2 Hardware Descri
p
tions